Instant video measuring software

3.3 Save template

After profile extraction, save the template for continuous measurement.

Steps：

1.  In the blank, enter the name of the template.

2. Click the Save button to save the template.

Now you can click the measurement button below to enter the continuous measurement interface and test whether the template just positioned the workpiece. Under the continuous measurement interface, click the Measure button.

If a green rectangular frame is displayed in the image display area, it indicates that the positioning is successful, as shown in Figure 3-4.

Figure 3-4

Then click the modify button at the bottom right to return to the measurement setting interface and modify the template. Use the tools under the tool panel to set the required measurement values, then save the modified template and enter the continuous measurement interface for continuous measurement.

3.4 Element tool

The software provides a variety of element tools for marking out points, arcs, and circles. After marking, use the measurement tool to measure the value of interest. The following describes how to use each function of the element tool.

Line

                                               Steps：

function：Extract a straight line from the image.    Step 1: Click the button and left click

on the line you want to extract to select

the starting point.

Step 2：Move the mouse to the end of the line and left click.

Step 3：Drag the mouse up or down to adjust the thickness of the extraction tool so that the lines you want to extract are completely included,left click,done.

Note: During the marking process, the workpiece to be measured must not be moved.

The dark blue rectangle is called a scan box. You can use the menu on the toolbar to show or hide the scan box.